This diagnostic test functions on the assumption that a sudden decrease in vehicle speed is caused by a brake pedal application. When the powertrain control module (PCM) detects that there is a 4.2 km/h (2.6 mph) or greater decrease in vehicle speed within 0.25 seconds and a transition of the torque converter clutch (TCC) brake/cruise release switch without a transition of the stop lamp switch, the PCM sets DTC P1574.
This diagnostic procedure supports the following DTC:
DTC P1574 Stop Lamp Switch Circuit
• | DTCs P0502, P0503, P0719, and P0724 are not set. |
• | The engine speed is greater than 700 RPM. |
• | The Traction Control System (TCS) or the Antilock Brake System (ABS) are not active and have not failed. |
• | The vehicle speed is greater than 48 km/h (30 mph) in order to enable the diagnostic. |
• | The diagnostic will disable when the wheel speed is less than 16 km/h (10 mph). |
• | The vehicle speed decreases by at least 4.2 km/h (2.6 mph) within 0.25 seconds. |
• | The PCM detects a TCC brake/cruise release switch transition. |
• | The PCM does not detect a stop lamp switch transition. |
• | The PCM sets the stop lamp switch status to released. |
• | The PCM disables the operation of the Cruise Control System. |
• | A history DTC will clear after 40 malfunction free warm-up cycles, if failures are not reported by this or any other emission related diagnostic. |
• | The PCM receives a clear code command from the scan tool. |
• | Inspect for proper adjustment of the TCC brake/cruise release switch. Refer to Cruise Release Switch Adjustment . |
• | Refer to Exterior Lighting Systems Description and Operation in order to avoid a misdiagnosis. |
• | For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections . |
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference : Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Do the stop lamps operate properly? | Go to Step 3 | |
3 | Test the stop lamp switch signal circuit for an open or the high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and complete the repair? | Go to Step 6 | Go to Step 4 |
4 | Inspect for poor connections at the harness connector of the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 6 | Go to Step 5 |
5 | Replace the PCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 6 | -- |
6 |
Does the DTC reset? | Go to Step 2 | System OK |