The body control module (BCM) monitors the battery voltage through the battery positive voltage circuit from the TBC fuse.
This diagnostic procedure supports the following DTC:
DTC B1420 Device Voltage
The voltage supplied to the BCM is in the range of 7-26 volts.
• | The BCM senses a battery voltage above 16.7 volts. |
• | The above condition lasts for at least 1 second. |
• | The BCM will disable all its outputs. |
• | The setting of this DTC inhibits the setting of other DTCs. |
• | A current DTC clears when the malfunction is no longer present. |
• | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
• | The following may cause an intermittent: |
- | A damaged terminal |
- | A backed out terminal |
- | A poor terminal tension |
- | A chafed wire |
- | A broken wire inside the insulation |
• | When diagnosing an intermittent short or an open, manipulate the wire harness while watching the test equipment for changes. |
Step | Action | Values | Yes | No |
---|---|---|---|---|
Schematic Reference: Body Control System Schematics Connector End View Reference: Computer/Integrating Systems Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Is the battery voltage input parameter in the specified range? | 9.0-16.7 V | Go to Step 3 | Go to Step 4 |
3 | Is DTC B1420 set as a current DTC? | -- | Go to Step 7 | Go to Diagnostic Aids |
4 |
Is the measured value in the specified range? | 9.0-16.7 V | Go to Step 6 | Go to Step 5 |
5 | Test the battery positive voltage circuit for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Battery Inspection/Test in Engine Electrical |
6 | Test all of the ground circuits of the BCM for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Step 7 |
7 | Inspect for poor connections at the BCM harness connectors. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Step 8 |
8 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you find and correct the condition? | -- | System OK | Go to Step 1 |