GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 Canyon Pickup - 4WD 🢒 Preface 🢒 Cautions and Notices 🢒 Steering Wheel Inflatable Restraint Module Replacement

Removal Procedure

    Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.

    Caution: Refer to SIR Caution in the Preface section.

  1. Disable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling .

    2. Object Number: 1373040 Size: SH
  2. Locate the access holes (1) positioned on both sides of the steering wheel shroud.

    3. Object Number: 1373043 Size: SH
  3. Using a 5.5 mm or 1/4 inch socket with a long 1/4 inch drive handle, push the leaf spring fasteners (1) inward through the access holes.

    4. Object Number: 1373038 Size: SH
  4. Lift and partially remove the inflatable restraint steering wheel module from the steering wheel in order to expose the electrical connectors.
  5. Disconnect the electrical connectors (1).
  6. Disconnect the horn electrical connector (3).

    7. Important: Do not attempt to repair the inflatable restraint steering wheel module. The inflatable restraint steering wheel module is replaced only as an assembly.


    Object Number: 1373036 Size: SH
  7. Remove the inflatable restraint module from the steering wheel.
  8. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .

Installation Procedure

    Object Number: 1373038 Size: SH
  1. Position the inflatable restraint module to the steering wheel.
  2. Connect the electrical connectors (1) to the inflatable restraint steering wheel module.
  3. Connect the horn electrical connector (3).

    4. Object Number: 1373043 Size: SH
  4. Position the 4 alignment posts of the inflatable restraint module to the holes that are located on the steering wheel housing.
  5. Push the inflatable restraint module into the steering wheel to engage and latch the leaf spring fasteners (1).
  6. After installation, pull up on the sides of the inflatable restraint module to ensure the leaf spring fasteners are engaged.
  7. Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling .