Removal Procedure
- Disconnect the electrical connectors (2, 4) from the following components:
• | The clutch pedal position switch (1) |
• | The cruise control release switch (3) |
Important: A new retainer (3) is required after removal.
- Complete the following in order to disengage the retainer (3) from the clutch pedal pin.
2.1. | Insert a flat-bladed tool (4) between the clutch master cylinder push rod (1) and the clutch pedal (2). |
2.2. | Pry the clutch master cylinder push rod (1) away from the clutch pedal assembly (2). |
Discard the retainer (3).
- Remove the 4 nuts securing the clutch pedal assembly to the cowl.
- Remove the clutch pedal assembly from the vehicle.
Installation Procedure
- Position the clutch pedal assembly over the studs.
Notice: Refer to Fastener Notice in the Preface section.
- Install the clutch pedal assembly nuts.
Tighten
Tighten the clutch pedal assembly nuts to 20 N·m (15 lb ft).
- Insert a new retainer (3) into the clutch master cylinder push rod (1).
- Push the clutch master cylinder push rod (1) onto the clutch pedal pin to secure.
- Connect the electrical connectors (2, 4) to the following components:
• | The clutch pedal position switch (1) |
• | The cruise control release switch (3) |
- Adjust the clutch release switch. Refer to
Clutch Pedal Cruise Control Release Switch Adjustment
.
- Adjust the clutch pedal position switch. Refer to
Clutch Pedal Position Switch Replacement
.
- Check for proper clutch pedal movement and operation.