GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Canyon Pickup - 4WD 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition Lock Cylinder Case Replacement

Removal Procedure
  1. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  2. Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement .

    3. Object Number: 1492304 Size: SH
  3. Remove the shear bolt from the ignition lock cylinder case using a hammer and chisel.
  4. Remove the ignition lock cylinder case.

Installation Procedure

    Object Number: 1492304 Size: SH
  1. Install the ignition lock cylinder case.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the ignition lock cylinder case bolt and tighten it until the head shears off.
  3. Install the multifunction turn signal switch. Refer to Multifunction Turn Signal Switch Housing Replacement .
  4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  5. The passlock sensor is part of the ignition switch. If replacing the ignition switch, a passlock relearn will be needed. Refer to Control Module References .