Special Tools

For equivalent regional tools, refer to Special Tools

1. Install the crankshaft balancer using EN-48034 installer .
2. Remove EN-48034 installer .
3. Hold the flywheel or back of the crankshaft. The crankshaft balancer does not have a keyway so the crankshaft could turn when tightening, causing an improper torque.

Caution: Refer to Fastener Caution in the Preface section.




4. Install the crankshaft balancer washer and new bolt.

4.1.	Tighten the new crankshaft balancer bolt while holding the back to 150 N·m (110 lb ft).

4.2.	Use J 45059 meter to tighten the crankshaft balancer bolt an additional 180 degrees.