GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2009 🢒 Canyon Pickup - 4WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Crankshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1899315 Size: SH
  1. Remove the starter. Refer to Starter Motor Replacement.
  2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.

    3. Object Number: 55322 Size: SH
  3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  4. Remove the CKP sensor bolt.
  5. Remove the CKP sensor.

Installation Procedure

    Object Number: 55322 Size: SH
  1. Install the CKP sensor.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the CKP sensor bolt.

    3. Tighten
    Tighten the bolt to 25 N·m (18 lb ft).


    Object Number: 1899315 Size: SH
  3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
  4. Install the starter. Refer to Starter Motor Replacement.
  5. Perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn.