1

Pick Up Box Side Molding

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Procedure

1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
2. Use a J 25070 Heat Gun to remove the pick up box side molding.
3. When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
4. Clean all the adhesive from the pick up box side, wipe the surface dry with a clean lint-free towel prior to installing new pick up box side molding.
5. Peel the protective liner from the adhesive tape and secure the pick up box side molding.
6. Using a towel and hand pressure, wet out the entire length of the molding starting at the rear edge working forward.