For 1990-2009 cars only
Removal Procedure
- Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement.
- Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement.
- Remove the bolt retaining the rear door check link to the body.
- Remove the rear door wiring harness grommet from the body by depressing the retaining tabs (1).
- Disconnect the rear door wiring harness to main body harness connector.
- Disconnect the rear door wiring harness connectors from all door hardware.
- Note the routing of the rear door wiring harness and disconnect the harness retainers from the inner door panel.
- Remove the rear door wiring harness grommet from the door.
- Remove the rear door wiring harness from the rear door.
Installation Procedure
- Install the rear door wiring harness to the rear door.
- Install the rear door wiring harness grommet to the door.
- Route the wiring harness through the door and connect the harness retainers to the inner door panel.
- Connect the rear door wiring harness connectors to all door hardware.
- Connect the rear door wiring harness to the main body harness connector.
- Install the rear door wiring harness grommet to the body ensuring the retaining tabs (1) are fully seated.
- Install the bolt retaining the rear door check link to the body and tighten to 25 N·m (18 lb ft).
- Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement.
- Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement.
Caution: Refer to Fastener Caution in the Preface section.
