Special Tools

J 39194-B Heated Oxygen Sensor Wrench

Caution: When replacing the HO2S perform the following:

Caution: Refer to Heated Oxygen and Oxygen Sensor Caution in the Preface section.

1. Remove the connector position assurance (CPA) retainer.
2. Disconnect the engine wiring harness electrical connector (1) from the heated oxygen sensor (HO2S) electrical connector.
3. Remove the HO2S sensor electrical connector from the camshaft cover.

Caution: Refer to Excessive Force and Oxygen Sensor Caution in the Preface section.




4. Using the J 39194-B remove the HO2S from the exhaust manifold.

Note: Use special anti-seize compound on the HO2S threads. The compound consists of graphite suspended in fluid and glass beads. The graphite burns away, but the glass beads remain, making the sensor easier to remove. New service sensors already have the compound applied to the threads. If you remove an oxygen sensor and if for any reason you must install the same oxygen sensor, apply the anti-seize compound to the threads before reinstallation.

1. Coat the threads of the HO2S with the anti-seize compound P/N 5613695, or equivalent if necessary.
2. Thread the HO2S into the exhaust manifold by hand.

Caution: Refer to Component Fastener Tightening Caution in the Preface section.

3. Using the J 39194-B , tighten the HO2S.

Tighten
Tighten the HO2S to 42 N·m (31 lb ft).




4. Install the HO2S sensor electrical connector to the camshaft cover.
5. Connect the engine wiring harness electrical connector (1) to the HO2S electrical connector.
6. Install the CPA retainer.