• | J 8433-1 Puller Bar |
• | J 41478 Crankshaft Front Oil Seal Installer |
• | J 41558 Crankshaft Sprocket Remover |
• | J 41665 Crankshaft Balancer and Sprocket Installer |
• | J 41816-2 Crankshaft End Protector |
Notice: Do not turn the crankshaft assembly after the timing chain has been removed in order to prevent damage to the piston assemblies or the valves.
Install the sprocket onto the crankshaft until fully seated against the crankshaft flange.
Important:
• Properly locate the camshaft sprocket locating pin with the camshaft sprocket alignment hole. • The sprocket teeth and timing chain must mesh. • The camshaft and the crankshaft sprocket alignment marks MUST be aligned properly. Locate the camshaft sprocket alignment mark in the 6 o'clock position.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 35 N·m (26 lb ft).