Adjustment Procedure
- Swing the endgate open.
- Loosen the screws retaining the endgate window run channels. Refer to
Window Run Channels Replacement - Endgate Lower
.
- Remove the regulator adjustment covers (3)
from the endgate.
- Loosen the lower regulator attachment nuts (2).
- Adjust the fore/aft position of the endgate window by turning the adjustment
screw (1).
| • | To move the top edge of the window rearward, turn the adjustment screws
clockwise. |
| • | To move the top edge of the window forward, turn the adjustment screws
counterclockwise. |
| • | Each adjustment screw must be adjusted equally. |
| • | Each revolution of the adjustment screw moves the top edge of the window
1.5 mm (0.06 in) forward or rearward. |
| • | Maximum adjustment is 5 revolutions in either direction. |
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the lower regulator attachment nuts (2). Ensure the adjustment
screw does not turn.
Tighten
Tighten the regulator attachment nuts to 25 N·m (18 lb ft).
- Tighten the screws retaining the endgate window run channels. Refer to
Window Run Channels Replacement - Endgate Lower
.
- Install the regulator adjustment covers (3) to the endgate.
