Removal Procedure
- Remove the fastener access cover (1).
- Remove the bolt (2) retaining the applique to the roof.
- Place the tape along the lower end of the applique in order to protect the painted surfaces.
- Lift the front of the applique (3) in order to visually see the snap-in fasteners.
- Starting from the front, working rearward, insert a long flat-bladed tool between the applique and the fastener and twist the tool in order to release the 4 fasteners.
- Remove the applique (3).
- Inspect the applique and snap-in fasteners for damage.
Installation Procedure
- Align the applique (3) to the vehicle.
- Insert the upper flange into the roof rail (4).
- Align the snap-in fasteners to the holes in the roof.
- Press the applique downward until all 4 fasteners lock into place.
Notice: Refer to Fastener Notice in the Preface section.
- Install the bolts (2).
Tighten
Tighten the bolts (2) to 10 N·m (89 lb in).
- Install the fastener access covers (1).