For 1990-2009 cars only
Removal Procedure
- Lower the endgate window approximately halfway down.
- Swing the endgate open.
- Remove the endgate window outer sealing strip. Refer to Endgate Window Outer Sealing Strip Replacement .
- Remove the endgate trim panel. Refer to Endgate Trim Panel Replacement .
- Remove the inner reinforcement panel. Refer to Endgate Inner Panel Reinforcement Replacement .
- Disconnect the electrical connectors from the defogger grid on the window.
- Remove the bolts (2) retaining the endgate window clips (1) to the regulator carrier plates.
- Remove the window from the endgate.
Installation Procedure
- Install the endgate window to the endgate. Ensure the window is engaged in the run channels.
- Install the window clips (1) down onto the regulator carrier plates.
- Install the bolts (2) retaining the window to the regulator carrier plates.
- Connect the electrical connectors to the defogger grid on the endgate window.
- Install the inner reinforcement panel. Refer to Endgate Inner Panel Reinforcement Replacement .
- Install the interior trim panel. Refer to Endgate Trim Panel Replacement .
- Install the endgate window outer sealing strip. Refer to Endgate Window Outer Sealing Strip Replacement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the window bolts to 12 N·m
(106 lb in).
