Rear Seat Replacement TrailBlazer EXT, Envoy XL
Removal Procedure
- Remove the communication interface module if removing the right-hand rear seat. Refer to
Communication Interface Module Replacement
in Cellular Communications.
- Remove the front two rear seat mounting nuts (2) securing the seat to the vehicle.
- Fold the seat to the stowed position.
- Remove the rear two rear seat mounting nuts (2) securing the seat to the vehicle.
- Remove the seat from the vehicle.
Installation Procedure
- Position the seat on the floor studs. The seat should be in the folded position.
- Install the two rear nuts (2). Do not tighten the nuts.
- Unfold the seat to ensure that the seat latch (1) properly engages the latch bar (3) the floor.
Notice: Refer to Fastener Notice in the Preface section.
- Install the front two rear seat mounting nuts (2).
Tighten
Tighten the front rear seat mounting nuts to 45 N·m (33 lb ft).
- Fold the seat to the stowed position.
- Tighten the two rear seat mounting nuts (2).
Tighten
Tighten the rear seat mounting nuts to 45 N·m (33 lb ft).
- Install the communication interface module if installing the right-hand rear seat. Refer to
Communication Interface Module Replacement
in Cellular Communications.