The driver door module supplies battery positive voltage to the power mirror switch. When the mirror direction switch is placed in the up or down position, the appropriate signal circuit is switched to battery voltage. The driver door module senses the voltage change and activates the selected outside rearview mirror in the appropriate direction.
• | Battery voltage must be between 9.0-16.0 volts. |
• | The ignition switch is in the ON position. |
The driver door module senses an active state on both the mirror switch up and down signal circuits greater than 3 seconds.
The driver door module will ignore the continuous inputs from the switch. The driver door module will respond to all other valid switch inputs.
When the fault is no longer present, the door module changes the current DTC to a history DTC. The door module will clear the history DTC after 50 fault free ignition cycles, or in response to a scan tool command.
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
1 | Did you perform the Door Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the scan tool display Idle? | -- | Go to Step 3 | Go to Step 4 |
3 |
Does the Mirror Switch Vertical data parameter change state with each selection? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Does the scan tool display Idle? | -- | Go to Step 7 | Go to Step 5 |
5 | Inspect for poor connections at the harness connector of the driver door module. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 6 |
6 |
Important: Perform the set up procedure for the driver door module. Refer to Door Control Module Programming/RPO Configuration . Replace the door module. Refer to Door Lock and Side Window Switch Replacement - Driver Side . Did you complete the replacement? | -- | Go to Step 8 | -- |
7 | Replace the mirror switch. Refer to Power Mirror Switch Replacement . Did you complete the replacement? | -- | Go to Step 8 | -- |
8 |
Does the DTC reset? | -- | Go to Step 2 | System OK |