Headlamp Housing Panel Replacement Chevrolet , GMC
Removal Procedure
- Remove the headlamp assemblies. Refer to
Headlamp Replacement
in Lighting Systems.
- Remove the grille. Refer to
Grille Replacement
in
Exterior trim.
- Remove the radiator baffle. Refer to
Air Intake Baffle Replacement - Radiator
.
- Release the clip that retains the ambient temperature sensor to the headlamp
panel assembly.
- Remove the bolts that retain the headlamp
panel assembly to the body.
- Remove the headlamp panel assembly from the vehicle.
Installation Procedure
- Position the headlamp panel assembly to
the vehicle.
- Feed the headlamp electrical connector through the access hole in the
headlamp panel assembly.
- Feed the remaining headlamp harness connectors between the outer edge
of the headlamp panel and the forward portion of the body.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the bolts that retain the headlamp panel assembly to the body.
Tighten
Tighten the bolts to 8 N·m (71 lb in).
- Install the clip that retains the ambient temperature sensor to the headlamp
panel assembly.
- Install the radiator baffle to the vehicle. Refer to
Air Intake Baffle Replacement - Radiator
.
- Install the grille. Refer to
Grille Replacement
in Exterior trim.
- Install the headlamp assemblies. Refer to
Headlamp Replacement
in Lighting Systems.
Headlamp Housing Panel Replacement Oldsmobile
Removal Procedure
- Remove the headlamp assemblies. Refer to
Headlamp Replacement
in Lighting Systems.
- Remove the grille. Refer to
Grille Replacement
in
Exterior trim.
- Remove the radiator baffle. Refer to
Air Intake Baffle Replacement - Radiator
.
- Release the tabs that retains the ambient temperature sensor to the headlamp
panel assembly.
- Remove the bolts that retain the headlamp
panel assembly to the body.
- Remove the headlamp panel assembly from the vehicle.
Installation Procedure
- Position the headlamp panel assembly to
the vehicle.
- Feed the headlamp electrical connector through the access hole in the
headlamp panel assembly.
- Feed the remaining headlamp harness connectors between the outer edge
of the headlamp panel and the forward portion of the body.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the bolts that retain the headlamp panel assembly to the
body.
Tighten
Tighten the bolts to 8 N·m (71 lb in).
- Install the ambient temperature sensor to the headlamp panel assembly,
ensure the retaining tabs are fully seated.
- Install the radiator baffle to the vehicle. Refer to
Air Intake Baffle Replacement - Radiator
.
- Install the grille. Refer to
Grille Replacement
in
Exterior trim.
- Install the headlamp assemblies. Refer to
Headlamp Replacement
in Lighting Systems.