Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Open the liftgate.
- Remove the upper quarter trim. Refer to
Rear Quarter Upper Trim Panel Replacement
in Interior Trim.
Notice: In order to avoid damaging the antenna lead connector, follow these
guidelines:
| • | Use a plastic tool and carefully pry the connector from the window. |
| • | Do NOT pull on the connector, which may be stuck to the urethane
adhesive or the headliner. |
- Disconnect the antenna lead located on the rear quarter window, if equipped. Refer to
Radio Control Module Replacement
or
Radio Antenna Module Replacement
in Entertainment.
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Important: Keep the cutting edge of the tool against the window. Do this from inside the vehicle.
- This will allow the urethane adhesive to be separated from the window.
| • | Leave a base of urethane on the pinchweld flange. |
| • | The only suitable lubrication is clear water. |
| • | UseJ 39032
or equivalent in order to remove the window. |
- If the original reveal molding on the quarter window is damaged it must be replaced.
- With the aid of an assistant, remove the quarter window from the opening.
