Instrument Panel Accessory Trim Plate Replacement Chevrolet
Removal Procedure
- Remove the center console. Refer to
Console Replacement
.
- Remove the center lower closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement
.
- Remove the lower trim plate retaining screws.
- Starting at the bottom of the trim plate, release the 2 lower retaining clips and the 2 intermediate retaining clips.
- Release the 3 upper retaining clips.
- Disconnect the electrical connectors as necessary.
- If replacing the trim plate, perform the following steps:
Installation Procedure
- If installing a new trim plate, perform the following steps:
- Connect the electrical connectors as necessary.
- Install the trim plate to the IP. Ensure that all of the retaining clips are properly seated.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the lower trim plate retaining screws.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
- Install the center closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement
.
- Install the center console. Refer to
Console Replacement
.
Instrument Panel Accessory Trim Plate Replacement Oldsmobile
Removal Procedure
- Remove the console shift lever bezel. Refer to
Console Shift Lever Bezel Replacement
.
- Remove the lower trim plate retaining screws.
- Starting at the bottom of the trim plate, release the 2 lower retaining
clips and the 2 intermediate retaining clips.
- Release the 3 upper retaining clips.
- Disconnect the electrical connectors as necessary.
- If replacing the trim plate, perform the following steps:
Installation Procedure
- If installing a new trim plate, perform the following steps:
- Connect the electrical connectors as necessary.
- Install the trim plate to the IP. Ensure that all of the retaining clips
are properly seated.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the lower trim plate retaining screws.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
- Install the console shift lever bezel. Refer to
Console Shift Lever Bezel Replacement
.