Removal Procedure
- Block the wheels to prevent the vehicle from moving.
- Remove the floor shift control knob. Refer to
Floor Shift Control Knob Replacement
in Automatic Transmission.
- Remove the center console.
Console Replacement
- Disconnect the automatic transmission range selector cable. Refer
to
Range Selector Lever Cable Replacement
in Automatic Transmission.
- Disconnect the electrical
connector from the automatic transmission shift interlock solenoid.
- Disconnect the electrical connector from the park brake.
- Remove the console bracket from the vehicle, by removing the retaining
nuts (1) from the center instrument panel (IP) bracket.
- Remove the forward retaining screw, if equipped.
- Remove the remaining fasteners from the console bracket.
- Remove the console bracket from the vehicle.
- Remove the floor shift control. Refer to
Transmission Control Replacement
in Automatic Transmission.
Installation Procedure
- Install the floor shift control. Refer to
Transmission Control Replacement
in Automatic Transmission.
- Install the console bracket
to the vehicle.
- Loosely install all the fasteners that retain the console bracket
to the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the retaining
nuts (1) to the center IP bracket.
Tighten
Tighten nuts to 10 N·m (88 lb in).
- Install the remaining fasteners that retain the console bracket
to the vehicle.
Tighten
Tighten the nuts to 25 N·m (18 lb ft).
- Connect the electrical connector to the park brake.
- Connect the electrical connector to the automatic transmission
shift interlock solenoid.
- Connect the automatic transmission range selector cable. Refer
to
Range Selector Lever Cable Replacement
in Automatic Transmission.
- Install the center console.
Console Replacement
- Install the floor shift control knob. Refer to
Floor Shift Control Knob Replacement
in Automatic Transmission.
- Remove the wheel blocks from the vehicle.