GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2002 🢒 Envoy - 2WD 🢒 Body and Accessories 🢒 Entertainment 🢒 Antenna Cable Replacement

Removal Procedure

    Object Number: 734416 Size: SH
  1. Open the instrument panel (I/P) compartment to a full down position.
  2. Disconnect the radio antenna cable (2) from the radio extension cable.
  3. Remove the lower rear portion of the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.

    4. Object Number: 718019 Size: SH
  4. Reach up behind the wheelhouse panel and remove the antenna cable and grommet assembly from the cowl opening (1).
  5. Pass the end of the radio antenna cable assembly through the cowl opening (1).
  6. Remove the antenna mast. Refer to Fixed Antenna Mast Replacement .
  7. Open the hood.

    8. Object Number: 718023 Size: SH
  8. Remove the radio antenna cable assembly retaining screws.
  9. Pass the antenna cable and grommet assembly through the fender opening.
  10. Remove the radio antenna cable assembly from the vehicle.

Installation Procedure

    Object Number: 718023 Size: SH
  1. Install the radio antenna cable assembly to the vehicle.
  2. Pass the antenna cable and grommet assembly through the fender opening.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the radio antenna cable assembly retaining screws.

    4. Tighten
    Tighten the radio antenna cable assembly screws to 2.8 N·m (25 lb in).

  4. Close the hood.
  5. Install the antenna mast. Refer to Fixed Antenna Mast Replacement .

    6. Object Number: 718019 Size: SH
  6. Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
  7. Install the antenna cable grommet assembly to the cowl opening.
  8. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.

    9. Object Number: 734416 Size: SH
  9. Install the radio antenna cable (2) to the radio extension cable.
  10. Close the I/P compartment.