Removal Procedure
- Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
- Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
- Remove the lock cylinder. Refer to Ignition Lock Cylinder Replacement in Steering Wheel and Column.
- Disconnect the connector from the theft deterrent control module.
- If necessary, disconnect the connector from the ignition lock cylinder case (1).
- Remove the theft deterrent control module (2) from ignition lock cylinder case assembly (1).
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Install the theft deterrent control module (2) onto the ignition lock cylinder case assembly (1).
- Connect the connector to the theft deterrent control module.
- If necessary, connect the connector to the ignition lock cylinder case.
- Install the lock cylinder. Refer to Ignition Lock Cylinder Replacement in Steering Wheel and Column.
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
- Program the Theft Deterrent Control Module. Refer to Programming Theft Deterrent System Components .
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
