Removal Procedure
- Remove the air cleaner cover (2), the filter element (6), the
mass air flow (MAF)/intake air temperature (IAT) sensor (3), and the air inlet
duct (5) from the lower air cleaner housing/washer solvent tank assembly (4).
Refer to
Air Cleaner Element Replacement
.
- Disconnect the following electrical connectors:
• | Windshield washer pump (1) |
• | Headlamp washer pump (2), if equipped |
• | Low solvent level sensor (4) |
• | Lift gate washer pump (6), if equipped |
- Remove the washer solvent level sensor wire harness from the wire harness
retaining clips (3, 5).
- If applicable, disconnect the headlamp washer hose from the headlamp washer
pump located on the lower air cleaner housing/washer solvent tank. Cap the headlamp
washer pump outlet fitting to prevent loss of washer solvent.
- Disconnect the washer pump hoses (3)
and plug the washer pump outlet ports to prevent loss of washer solvent.
- Remove the 2 air cleaner housing/washer solvent tank assembly retaining
nuts (1) from the mounting studs.
- Lift the lower air filter housing/washer solvent tank assembly (2)
off of the studs and remove the assembly.
Installation Procedure
- Install the lower air filter housing/washer
solvent tank assembly (2) onto the mounting studs.
- Connect the washer pump hoses (3) to the washer pumps.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 2 air cleaner housing/washer solvent tank assembly retaining nuts (1)
to the mounting studs.
Tighten
Tighten the nuts to 15 N·m (11 lb ft).
- If applicable, connect the headlamp washer hose to the headlamp
washer pump located on the lower air cleaner housing/washer solvent tank.
- Connect the following electrical connectors:
• | Windshield washer pump (1) |
• | Headlamp washer pump (2), if equipped |
• | Low solvent level sensor (4) |
• | Lift gate washer pump (6), if equipped |
- Install the washer solvent level sensor wire harness to the wire harness
retaining clips (3, 5).
- Install the air cleaner cover (2), the filter element (6), the
mass air flow (MAF)/intake air temperature (IAT) sensor (3), and the air inlet
duct (5) to the lower air cleaner housing/washer solvent tank assembly (4).
Refer to
Air Cleaner Element Replacement
.