Removal Procedure
- Remove the left closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
.
- Remove the knee bolster trim panel. Refer to
Driver Knee Bolster Panel Replacement
.
- Remove the 2 headlamp trim plate retaining
nuts.
- Use a plastic flat bladed tool in order to release the retaining
clips.
- Remove the headlamp trim plate from the instrument panel (IP).
Installation Procedure
- Install the headlamp trim plate to the
IP, ensuring the retaining clips are fully seated.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 2 headlamp trim plate retaining screws.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
- Install the knee bolster trim panel. Refer to
Driver Knee Bolster Panel Replacement
.
- Install the left closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
.