The rear wiper motor is supplied battery positive voltage and ground. The liftgate control module controls rear wiper motor operation through the rear wiper motor control circuit. The rear wiper motor control circuit is supplied a battery positive reference voltage by the rear wiper motor module and is pulse width modulated to ground by the liftgate control module. The duty cycle of the pulse width modulation determines the rear wiper motor operating mode.
Battery voltage must be between 9-16 volts.
The rear wiper motor control circuit is shorted to voltage.
The rear wiper/washer system will be disabled for as long as the DTC is current.
• | The DTC will be current for as long as the fault is present and it will be latched for the respective ignition cycle. |
• | A history DTC will be cleared after 100 error free ignition cycles. |
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Wiper/Washer Connector End Views | ||||
1 | Did you perform the Wiper/Washer System Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the rear wiper motor operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the test lamp illuminate? | -- | Go to Step 4 | Go to Step 8 |
4 | Connect a test lamp from the battery positive voltage supply circuit terminal to the ground circuit terminal in the rear wiper motor harness connector. Does the test lamp illuminate? | -- | Go to Step 5 | Go to Step 9 |
5 |
Is the voltage within the specified values? | 10-14 V | Go to Step 6 | Go to Step 7 |
6 | Test the rear wiper motor control circuit for high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 14 | Go to Step 12 |
7 | Test the rear wiper motor control circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 14 | Go to Step 10 |
8 | Repair the battery positive voltage circuit to the rear wiper motor. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 14 | -- |
9 | Repair the rear wiper motor ground circuit for an open or high resistance. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 14 | -- |
10 | Inspect for poor connections at the harness connector of the rear wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 14 | Go to Step 11 |
11 | Replace the rear wiper motor. Refer to Rear Window Wiper Motor Replacement . Did you complete the replacement? | -- | Go to Step 14 | -- |
12 | Inspect for poor connections at the harness connector of the liftgate control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 14 | Go to Step 13 |
13 |
Important: Perform the setup procedure for the liftgate control module. Replace the liftgate control module. Refer to Liftgate Control Module Replacement in Body Rear End. Did you complete the replacement? | -- | Go to Step 14 | -- |
14 |
Does the DTC reset? | -- | Go to Step 2 | System OK |