Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Brake Warning System Schematics Connector End View Reference: Hydraulic Brake Connector End Views | |||
1 | Did you review the Brake Warning System Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Verify a fault is present. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the brake warning indicator illuminate? | Go to Step 4 | Go to Step 15 |
4 |
Does the Park Brake status change from Released to Set? | Go to Step 5 | Go to Step 6 |
5 |
Does the brake warning indicator illuminate? | Go to Step 12 | Go to Step 7 |
6 |
Does the brake warning indicator illuminate? | Go to Step 11 | Go to Step 8 |
7 | Connect a fused jumper wire between the brake fluid level switch output circuit and a good ground. Does the brake warning indicator illuminate? | Go to Step 9 | Go to Step 10 |
8 | Test park brake switch output circuit for an open between the park brake switch and the BCM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 13 |
9 | Repair the open in the ground circuit of the brake fluid level switch. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 16 | -- |
10 | Test the brake fluid level switch input circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 16 | Go to Step 14 |
11 | Replace the park brake switch. Refer to Parking Brake Indicator Switch Replacement in Park Brake. Did you complete the replacement? | Go to Step 16 | -- |
12 | Replace the brake fluid level switch. Refer to Master Cylinder Reservoir Replacement . Did you complete the replacement? | Go to Step 16 | -- |
13 |
Important: Perform the set up procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | Go to Step 16 | -- |
14 |
Important: Following EBCM replacement, use the scan tool to perform the Tire Size Calibration procedure. Replace the EBCM. Refer to Electronic Brake Control Module Replacement in Antilock Brake System. Did you complete the replacement? | Go to Step 16 | -- |
15 | Replace the instrument panel cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console. Did you complete the replacement? | Go to Step 16 | -- |
16 | Verify the system is repaired. Does the system operate normally? | System OK | Go to Step 3 |