Rocker Panel Molding Replacement TrailBlazer, Envoy, Bravada
Tools Required
J 36796 Clip Removal
Tool
Removal Procedure
- Remove the front rocker molding scuff plate. Refer to
Front Rocker Molding Scuff Plate Replacement
.
- Remove the rear rocker molding scuff plate. Refer to
Rear Rocker Molding Scuff Plate Replacement
.
- Remove the assist step. Refer to
Assist Step Replacement
in Frame and Underbody.
- Remove the rocker panel molding bolts
located at each end of the rocker panel molding.
- Use the J 36796
in
order to remove the 7 push-pins that retain the bottom of the rocker panel
molding to the body.
- Remove the rocker panel molding from the vehicle.
Installation Procedure
- Position the rocker panel molding to the
body.
- Install the 7 push-pins that retain the bottom of the rocker panel molding
to the body.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the rocker panel molding bolts located at each end of the rocker panel
molding.
Tighten
Tighten the rocker panel molding bolts to 7 N·m (62 lb ft).
- Install the assist step. Refer to
Assist Step Replacement
in Frame and Underbody.
- Install the front rocker molding scuff plate. Refer to
Front Rocker Molding Scuff Plate Replacement
.
- Install the rear rocker molding scuff plate. Refer to
Rear Rocker Molding Scuff Plate Replacement
.
Rocker Panel Molding Replacement TrailBlazer EXT, Envoy XL
Removal Procedure
- Use a flat-bladed tool to remove door sill plates from top of rocker molding.
- Remove screw (1) from front of rocker panel molding.
- Release the push-in retainers (2) from the lower rocker panel molding
using a trim removal tool.
- Remove upper push in retainer (3).
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing
an emblem/name plate.
- Remove the rocker panel molding
from the rocker panel.
Installation Procedure
- Position rocker molding to the holes in the rocker panel.
- Install door sill plates on top of rocker molding, ensuring that the retaining
tabs are thoroughly engaged.
- Install upper push-in retainer (1), pressing into place until fully seated.
- Install the push-in retainers (3) in the bottom of the rocker molding.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the rocker molding screw (2) to the rocker molding.
Tighten
Tighten the screw to 6 N·m (53 lb in).