Tools Required

Important: The interior trim panels do not have to be removed to remove the bodyside window frame.

1. Ensure the body side window is in the full closed position. If not, the window actuator will need to be adjusted.
2. If the actuator is not being replaced, perform the following 2 steps.



3. Position the bellcrank (1) at a 45 degree angle (2) compared to the vertical edge of the window side sheet metal (4).



4. Using the body side power window switches (1 or 2) at the overhead console, push the switch in order to position the bellcrank at a 45 degree angle to the sheet metal flange.

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a body side window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.

5. Open the rear doors.
6. Cover to protect the following parts from broken glass if necessary:

6.1.	Defroster outlets and A/C outlets.

6.2.	Seats and carpeting.




7. Disconnect the window bracket to actuator arm (1) by loosening screw (2).




Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

8. From the exterior of the vehicle, wearing safety gloves and goggles, pull the body side window outward and forward until the front body side window hinge releases from the window frame (2). Discard the body side window.




Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Important: Keep the cutting edge of the tool against the body side window frame . Do this from outside side the vehicle.

9. This will allow the urethane adhesive to be separated from the body side window frame.

•	Leave a base of urethane on the pinchweld flange.

•	The only suitable lubrication is clear water.

•	Use the J 39032 or equivalent in order to remove the body side window frame.




10. Remove the window frame (1) from the body side opening.

1. Install the body side window into the opening. Refer to Adhesive Installation of Bodyside Stationary Windows .
2. Remove the double layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.



3. Insert the actuator screw into the slot on the window bracket.

Notice: Refer to Fastener Notice in the Preface section.

4. Tighten the actuator screw.

Tighten
Tighten the screw to 5 N·m (44 lb in).




5. Remove the window bracket (3) to the window frame pin (1) prior to operating the body side window.

Caution: Insufficient curing of urethane adhesive may allow unrestrained occupants to be ejected from the vehicle resulting in personal injury.

Important: The actuator screw must be tightened and the window frame pin must be removed for the window to function properly.