Removal Procedure
- Ensure that the vehicle is in the park position.
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the end of the range selector cable from the transmission range selector lever ball stud (6).
- Remove the retainer (5) from the range selector cable.
- Remove the range selector cable (4) from the bracket (1).
- Remove the cable from the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, remove the cable from the retainers located on the transfer case.
- Push the cable grommet (2) up through the floor panel.
- Lower the vehicle.
- Remove the console. Refer to
Console Replacement.
- Remove the drivers side front mat and carpet. Refer to
Front Floor Panel Carpet Replacement .
- Remove the end of the range selector cable (1) from the floor control ball stud.
- Remove the range selector cable (2) from the floor shift control assembly.
- Remove the tape and grommet on the shift cable from the floor panel.
- Remove the range selector cable (3) from the vehicle.
Installation Procedure
- Push the cable down through the floor panel and install the grommet (2).
- Install the range selector cable (2) to the floor shift control assembly.
- Install the end of the range selector cable (1) to floor control ball stud.
- Install the drivers side front mat and carpet. Refer to
Front Floor Panel Carpet Replacement .
- Install the console. Refer to
Console Replacement.
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Install the cable to the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, install the cable to the retainers located on the transfer case.
- Install the range selector cable (4) to the bracket (1).
- Install the retainer (5) to the range selector cable.
- Install the end of the range selector cable to the transmission range selector lever ball stud (6).
- Adjust the range selector cable. Refer to
Range Selector Lever Cable Adjustment .
- Lower the vehicle and check for proper operation.