Diagnostic Instructions
Circuit/System Description
The keyless entry system is a vehicle entry device. The keyless entry will unlock/unlatch the vehicle doors or open the rear gate when a corresponding button on the key fob is pressed. This is accomplished by the key fob sending a radio frequency to the
liftgate module (LGM). The signal is received by the LGM via an internal antenna located within the LGM. The LGM interprets the signal and activates the requested function via a message over the class 2 serial data line. A low transmitter battery or radio
frequency (RF) interference from aftermarket devices such as 2-way radios, power inverters, cellular phone chargers, computers, etc. may cause a system malfunction. High RF traffic areas, such as gas stations which use pay-at-the-pump RF transponders, may also
cause interference that could lead to a malfunction.
Diagnostic Aids
For the
J 43241
Keyless Entry Tester, inspect the keyless entry transmitter part number to determine that it is the correct model for the vehicle. A wrong model transmitter may pass the test, but it
will not activate the vehicle remote system.
Reference Information
Schematic Reference
Remote Function Schematics
Connector End View Reference
Remote Function Connector End Views
Electrical Information Reference
Scan Tool Reference
Scan Tool Data List
Special Tools Required
J 43241
Keyless Entry Tester
Circuit/System Testing
- Verify that the transmitter is the correct transmitter for the vehicle.
⇒ | If not the correct transmitter, replace the transmitter. |
- Verify the scan tool FOB Programmed parameter is Yes.
⇒ | If not Yes, program the transmitter. |
- Place the transmitter on the test pad of the
J 43241
and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
⇒ | If none of the buttons sounds the tone and illuminates the green light, replace the battery. |
⇒ | If one or more of the buttons sounds the tone and illuminates the green light, replace the transmitter. |
- Verify the scan tool Last FOB Button Pressed parameter responds to every function on the transmitter.
⇒ | If it does not respond to every function, replace the LGM module. |
- Replace the transmitter.
Repair Instructions
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.