Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views

Did you review the Exterior Lighting Systems Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Exterior Lighting Systems Description and Operation

Verify that the hazard lamps are always on.

Do the hazard lamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Disconnect the turn/hazard flasher.
2. Ensure that the hazard lamp switch is in the OFF position.
3. Test for a ground signal at the hazard switch signal circuit input terminal of the hazard/turn flasher connector. Refer to Circuit Testing .

Is a ground signal present?

Go to Step 4

Go to Step 5

Test the multifunction turn signal switch hazard switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct a condition?

Go to Step 9

Go to Step 6

Inspect for poor connections at the harness connector of the hazard/turn flasher. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 7

Inspect for poor connections at the harness connector of the multifunction turn signal switch. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 8

Replace the hazard/turn flasher. Refer to Hazard and Turn Signal Flasher Replacement .

Did you complete the repair?

Go to Step 9

--

Replace the multifunction turn signal switch. Refer to Turn Signal Multifunction Switch Replacement .

Did you complete the repair?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3