GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Envoy - 2WD 🢒 Body Hardware and Trim 🢒 Instrument Panel and Console Trim 🢒 Front Floor Console Cup Holder Door Hinge Replacement

Removal Procedure
  1. Remove the front floor console cup holder assembly. Refer to Front Floor Console Rear Cup Holder Replacement.
  2. Remove the front floor console. Refer to Console Replacement.
  3. Turn the front floor console upside down in order to access the front floor console rear air duct assembly.

    4. Object Number: 2133667 Size: SH
  4. Remove the fastener  (1) that retains the front floor console rear air duct assembly  (2) to the front floor console assembly.
  5. Disconnect the electrical connections to the front floor console rear air duct assembly (2).
  6. Remove the front floor console rear air duct assembly (2) from the console.

    7. Object Number: 2133669 Size: SH
  7. Remove the fasteners (1) retaining the front floor console rear cup holder hinge assembly to the console.
  8. Turn the front floor console upward.

    9. Object Number: 2133670 Size: SH
  9. Slide the front floor console rear cupholder hinge assembly out of the front floor console assembly.

Installation Procedure

    Object Number: 2133670 Size: SH
  1. Slide the front floor console rear cupholder hinge assembly into the front floor console assembly.
  2. Turn the front floor console up side down.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 2133669 Size: SH
  3. Install the fasteners (1) retaining the front floor console rear cup holder hinge assembly to the front floor console.

    4. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  4. Install the front floor console rear air duct assembly (2) into the front floor console.
  5. Connect the electrical connections to the front floor console rear air duct assembly (2).

    6. Object Number: 2133667 Size: SH
  6. Install the fastener  (1) that retains the front floor console rear air duct assembly  (2) to the front floor console assembly.

    7. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  7. Install the front floor console. Refer to Console Replacement.
  8. Install the front floor console cup holder assembly. Refer to Front Floor Console Rear Cup Holder Replacement.