Caution: Refer to Approved Equipment for Collision Repair Caution in the Preface section.

1. Remove all of the related panels and components.
2. Restore as much of the damage as possible to the factory specifications.
3. Note the location and remove the following as necessary:

•	The sealers

•	The sound deadeners

•	The anti-corrosion materials





Important: Drill through the hinge bracket only.

4. Locate, and drill out all of the factory welds for installation of the service part.




Important: Do not damage any of the inner panels or reinforcements.

5. Remove the damaged hood hinge bracket.

Important: In any area with excessive damage, space the plug weld holes every 40 mm (1½ in) apart.

1. Drill 8 mm (5/16 in) plug weld holes in the service part as necessary in the locations noted from the original panel.



2. Prepare all of the mating surfaces as necessary.
3. Apply GM-approved Weld-Thru Coating or equivalent to all mating surfaces. Refer to Anti-Corrosion Treatment and Repair .
4. Position the hinge bracket.



5. Plug weld accordingly.



6. Clean and prepare all of the welded surfaces.
7. Apply the following as necessary:

•	The sound deadening materials

•	An approved anti-corrosion primer

•	The sealers and refinish as necessary

8. Install all of the related panels and components.