Removal Procedure
- Remove the right closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
.
- Remove the I/P storage compartment door. Refer to
Instrument Panel Compartment Door Replacement
.
- Disconnect the blower motor electrical connector.
- Remove the blower motor mounting screws.
- Remove the blower motor cooling tube.
- Remove the blower motor (2).
Installation Procedure
- Install the blower motor (2).
- Install the blower motor cooling tube.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the blower motor mounting screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Connect the blower motor electrical connector.
- Install the right closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
.