Removal Procedure
- Remove the cylinder number 2 spark plug and wire. Refer to
Spark Plug Replacement .
- Remove the oil level indicator from the tube.
- Remove the oil level indicator tube bolt.
- Remove the oil level indicator tube from the engine block.
Important: The O-ring seal may be reused if not cut or damaged.
- Inspect the O-ring seal for cuts or damage.
- Remove the O-ring seal from the tube, if required.
Installation Procedure
- Lubricate the O-ring seal with clean engine oil.
- Install the O-ring seal onto the oil level indicator tube.
- Install the oil level indicator tube behind the exhaust manifold.
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle .
- Install the oil level indicator tube into the block. Install the tube with the collar flush to the block.
Notice: Refer to Fastener Notice in the Preface section.
- Lower the vehicle.
- Install the oil level indicator tube bolt
Tighten
Tighten the bolt to 25 N·m (18 lb ft).
- Install the oil level indicator to the tube.
- Install the cylinder number 2 spark plug and wire. Refer to
Spark Plug Replacement .