Special Tools
• | J 45380
Transfer Case Rear Bushing Remover and Installer |
Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the rear propeller shaft. Refer to
Rear Propeller Shaft Replacement
.
- Remove the rear output shaft seal.
- Inspect the rear output shaft bushing for scoring or wear.
- Remove the rear output shaft bushing, if required, using the
J 45380
.
5.1. | Install the finger section of the
J 45380
. |
5.2. | Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out. |
5.3. | Using a wrench on the forcing screw, remove the rear output shaft bushing. |
Installation Procedure
- Using the
J 45380
, perform the following:
1.1. | Install the bushing or the finger section of the
J 45380
. |
1.2. | Install the finger section to the main body of the
J 45380
. |
1.3. | Position the bushing and tool to the case. |
1.4. | Install the bushing until the tool bottoms on the case. |
- Align the notch on the
J 37668-A
with the tab on the seal.
- Using the
J 37668-A
, install the seal with the tab at the top and the weep hole at the bottom.
- Install the rear propeller shaft. Refer to
Rear Propeller Shaft Replacement
.
- Inspect the transfer case fluid level. Refer to
Transfer Case Fluid Replacement
.
- Lower the vehicle. Refer to
Lifting and Jacking the Vehicle
.