Important: The electronic adjustable accelerator pedal, mounting bracket, return spring, and pedal position sensor are not serviced separately, but as a unit. The replacement accelerator assembly is already set in the full forward position.
Important: The electronic adjustable pedal (EAP) must be moved to the full forward position whenever work is done on or around the pedal assembly.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the mounting nuts to 11 N·m (97 lb in).
Tighten
Tighten the mounting nuts to 11 N·m (97 lb in).
Important: The following procedure must be performed before if the accelerator pedal or brake pedal drive motor and cable assembly are being replaced. Failure to do so could cause an IMPROPER STEP OVER HEIGHT.
4.1. | Turning the motor transmission clockwise reduces the gap, and counterclockwise increases the gap. |
4.2. | Position a 4.5 mm (0.187 in-3/16 in) drill bit or equivalent in number and/or letter drill bits, 6.35 mm (0.25 in-1/4 in) from the bottom of the metal accelerator pivot arm. |
4.3. | Rotating the drive cable by hand, adjust the accelerator motor transmission until the 4.5 mm (0.187 in-3/16 in) drill bit or equivalent in number and/or letter drill bits, fits snugly between the plastic accelerator arm and the metal pivot arm. |
Important: Ensure the secondary locking tabs are fully seated before installing the lock collar for the drive cable.