GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Envoy - 2WD 🢒 Body Systems 🢒 Wipers and Washers 🢒 Windshield Wiper Motor Cover Replacement

Removal Procedure
  1. Remove the wiper transmission assembly. Refer to Windshield Wiper Transmission Replacement .

    2. Object Number: 751559 Size: SH
  2. Remove the 3 screws retaining the wiper motor cover to the motor.
  3. Remove the wiper cover and module from the motor.

Installation Procedure

    Object Number: 751559 Size: SH
  1. Install the wiper cover and module to the wiper motor.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 3 screws retaining the wiper motor cover to the wiper motor.

    3. Tighten
    Tighten the 3 wiper motor cover screws to 3 N·m (27 lb in).

  3. Install the wiper transmission assembly to the vehicle. Refer to Windshield Wiper Transmission Replacement .