• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The electronic brake control module (EBCM) must be calibrated.
• | The ignition is ON. |
• | Ignition voltage is greater than 8 volts. |
The EBCM has not been calibrated.
• | The EBCM disables the ABS and the TCS for the duration of the ignition cycle. |
• | A DIC message and/or a warning message may be displayed. |
• | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
• | The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Antilock Brake System Schematics
Control Module References for Scan Tool information.
Calibrate the EBCM. Refer to Control Module References.
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM calibration