For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0201: Antilock Brake System (ABS) Enable Relay Contact CircuitCircuit/System Description
The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.
Conditions for Running the DTC
| • | Ignition voltage is greater than 9.5 volts. |
| • | The solenoid relay is commanded ON. |
Conditions for Setting the DTC
| • | The EBCM detects an open in the battery positive voltage circuit to the solenoid valve relay. |
| • | The EBCM detects a stuck open solenoid valve relay or an open circuit between the solenoid valve relay and solenoid valves. |
Action Taken When the DTC Sets
| • | The EBCM disables the Antilock Brake System (ABS)/Traction Control System (TCS)/dynamic rear proportion (DRP)/Vehicle Stability Enhancement System (VSES) for the duration of the ignition cycle. |
| • | A DIC message and/or a warning message may be displayed. |
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for EBCM
Circuit/System Verification
With the scan tool, access the ABS special functions menu and perform the ABS Motor test. The pump motor should function and no DTCs should be set.
Circuit/System Testing
- Test for an open or a short to ground in the solenoid valve battery positive voltage circuit terminal. Verify no open or a short to ground is found.
- Replace the EBCM/brake pressure modulator valve (BPMV) assembly.
| ⇒ | If open or a short to ground is found repair circuit. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for EBCM replacement, setup, and programming |
