Removal Procedures
- Remove rocker panel assembly. Refer to
Rocker Panel Molding Replacement
.
- Remove the door opening screws (1) from front of rocker panel rear molding.
- Release push-in retainers (2) using a trim removal tool.
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing
an emblem/name plate.
- Remove the rocker panel molding from the rocker panel.
Installation Procedure
- Position the rocker molding to the holes in the rocker panel.
Notice: Refer to Fastener Notice in the Preface section.
- Install the door opening screws (1).
Tighten
Tighten the screws to 6 N·m (53 lb in).
- Install push-in retainers.