Removal Procedure
- Remove the trim panel from the power seat by performing the following:
| 1.2. | Remove the 3 trim panel retaining screws. |
- Remove the trim panel from the manual seat by performing the following steps:
| 2.3. | Remove the screws from the trim panel. |
- Remove the trim panel from the seat assembly.
Installation Procedure
- Install the trim panel to the power seat by performing the following steps:
| 1.1. | Align the trim panel to the seat assembly. |
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
| 1.2. | Install the screws retaining the trim panel to the seat assembly. |
Tighten
Tighten the trim panel screws to 3 N·m (26 lb in).
| 1.3. | Install the 3 seat switch bezel mounting screws. |
Tighten
Tighten the seat switch bezel mounting screws to 3 N·m (26 lb ft).
- Install the trim panel to the manual seat by performing the following steps:
| 2.1. | Install the screws in the trim panel. |
