Caution: Refer to Brake Dust Caution in the Preface section.
6.1. | Install a large C-clamp over the top of the brake caliper housing and against the back of the outboard brake pad. |
6.2. | Slowly tighten the C-clamp until the pistons push into the brake caliper enough to slide the brake caliper off the rotor. |
6.3. | Remove the C-clamp from the brake caliper. |
Important: When installing new brake pads, DO NOT reuse the old retaining clips for the brake pad. Use only NEW brake pad retaining clips.
Important: Ensure that the retaining clip for the brake pads is properly seated in the brake caliper.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the brake caliper bolt to 31 N·m (23 lb ft).
Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal injury.