Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling .
- Tilt the steering column to the CENTER position.
- Remove the steering wheel from the column. Refer to
Steering Wheel Replacement.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement.
- If necessary, inspect the steering column for accident damage. Refer
to
Steering Column Accident Damage Inspection .
Important: If the steering wheel has PAD control, the
inflatable restraint steering wheel module coil and wire harness assembly must come
off as one piece.
If the steering wheel does not have PAD control, the
inflatable restraint steering wheel module coil will come off by itself.
- Remove the wire harness strap.
- If the steering wheel has PAD control, remove the wire harness assembly.
Refer to
Steering Column Wiring Harness Replacement.
- Remove the retaining ring (1) using snap ring
pliers.
- Remove the steering wheel module coil (2).
- If necessary, remove the wave washer (3).
Installation Procedure
- If necessary, install the wave washer (1).
- Align the block tooth on the steering shaft assembly (1)
to the 12 o'clock position.
Important: A new inflatable restraint steering wheel
module coil is pre-centered. Do not remove the centering tab from the new inflatable
restraint steering wheel module coil until installation is complete.
- If installing the existing inflatable restraint steering wheel module coil,
the coil must be centered first. Refer to
Inflatable Restraint Steering Wheel Module Coil Centering .
- Align the inflatable restraint steering wheel module coil (2)
with the horn tower sticking through the shaft lock or cam orientation plate (1).
- Slide the steering wheel module coil (2) onto the steering shaft
assembly.
- Remove and discard the centering tab from the coil.
Important: The retaining ring (1) must seat securely
on the groove of the race and upper shaft assembly (2).
- Install the retaining ring (1) using snap ring pliers.
Caution: Improper routing of the wire harness assembly may damage the inflatable
restraint steering wheel module coil. This may result in a malfunction of
the coil, which may cause personal injury.
- If the steering wheel has PAD control, install the wire harness assembly. Refer
to
Steering Column Wiring Harness Replacement .
- Install the wire harness strap.
- Install the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement .
- Install the steering wheel to the column. Refer to
Steering Wheel Replacement.
- Enable the SIR system. Refer to
SIR Disabling and Enabling .