GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1999 🢒 Envoy - 4WD 🢒 Body and Accessories 🢒 Exterior Trim 🢒 Body Side Rear Molding Replacement

Removal Procedure
  1. Remove the body side trim panel. Refer to Body Side Trim Panel Replacement

    2. Object Number: 1170 Size: SH
  2. Remove the body side molding to body nuts.
  3. Remove the body side molding from the body of the truck.

Installation Procedure

    Object Number: 1170 Size: SH
  1. Install the body side molding to the body of the truck.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the body side molding to the body nuts.

    3. Tighten
    Tighten the molding to body nuts to 2.8 N·m (23 lb in).

  3. Install the body side trim panel. Refer to Body Side Trim Panel Replacement