- Remove the key from the ignition switch.
- Connect the passenger
yellow 2-way connector located behind the glove box.
- Install the connector position assurance (CPA) to the passenger
yellow 2-way connector located behind the glove box.
- Close the IP compartment door.
- Connect the driver yellow
2-way connector located at the base of the steering column.
- Install the connector
position assurance (CPA) to the driver yellow 2-way connector located at the
base of the steering column.
- Install the knee bolster, if equipped. Refer to
Knee Bolster Replacement
in Instrument Panel, Gages and Console.
- Install the sound insulator-LH. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Interior Trim.
- Install the SIR Fuse to the IP fuse block.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
10.1. | The AIR BAG warning lamp will flash 7 times. |
10.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described.