For 1990-2009 cars only
Removal Procedure
- Remove the floor console. Refer to Console Replacement in Instrument Panel, Gages and Console.
- Disable the Park Brake Automatic Adjuster. Refer to Parking Brake Cable Adjuster Disabling .
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the park brake cables from the equalizer.
- Lower the vehicle.
- Disconnect the electrical connector from the park brake warning lamp switch.
- Remove the remaining park brake lever retaining nut.
- Remove the park brake lever assembly from the vehicle.
Installation Procedure
- Install the park brake lever assembly to the vehicle.
- Install the right front park brake lever retaining nut.
- Connect the electrical connector to the park brake warning lamp switch.
- Raise the vehicle.
- Connect the park brake cables to the equalizer.
- Lower the vehicle.
- Install the floor console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
- Enable the park brake automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the park brake lever mounting nut to 25 N·m (18 lb ft).
