Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable restraint
steering wheel module. Refer to
Disabling the SIR System
in SIR.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Tilt the column to the CENTER position.
- Disconnect the connectors from the turn signal and multifunction
switch assembly.
Remove 2 pan head tapping screws from the turn signal and multifunction
switch assembly.
- Remove the turn signal and multifunction switch assembly.
Installation Procedure
Important: The electrical contact on the turn signal and multifunction switch assembly
must rest on the turn signal cancel cam assembly.
- Install the turn signal and multifunction switch assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Secure by using
2 pan head tapping screws.
Tighten
• | Tighten the screw on the top of the column to 3 N·m
(27 lb in). |
• | Tighten the screw in the front to 7 N·m (62 lb in). |
- Connect the connectors to the turn signal and multifunction switch
assembly.
- Install the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Enable the inflatable restraint steering wheel module. Refer to
Enabling the SIR System
in SIR.