Instrument Panel Accessory Trim Plate Replacement GMC

1. Remove the center console. Refer to Console Replacement .
2. Remove the center lower closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement .



3. Remove the lower trim plate retaining screws.
4. Starting at the bottom of the trim plate, release the 2 lower retaining clips and the 2 intermediate retaining clips.
5. Release the 3 upper retaining clips.
6. Disconnect the electrical connectors as necessary.
7. If replacing the trim plate, perform the following steps:

7.1.	If equipped, remove the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement .

7.2.	Remove the rear windshield wiper switch. Refer to Rear Window Wiper and Washer Switch Replacement in Wiper/Washer Systems.

7.3.	If equipped, remove the cigar lighter and 12-volt power supply. Refer to 12-Volt Accessory Power Receptacle Replacement in Power Outlets.

1. If installing a new trim plate, perform the following steps:

1.1.	If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement in Power Outlets.

1.2.	Install the rear windshield wiper switch. Refer to Rear Window Wiper and Washer Switch Replacement in Wiper/Washer Systems.

1.3.	If equipped, install the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement .




2. Connect the electrical connectors as necessary.
3. Install the trim plate to the IP. Ensure that all of the retaining clips are properly seated.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the lower trim plate retaining screws.

Tighten
Tighten the screws to 2.5 N·m (22 lb in).

5. Install the center closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
6. Install the center console. Refer to Console Replacement .

Instrument Panel Accessory Trim Plate Replacement Oldsmobile/Buick

1. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .



2. Remove the lower trim plate retaining screws.
3. Starting at the bottom of the trim plate, release the 2 lower retaining clips and the 2 intermediate retaining clips.
4. Release the 3 upper retaining clips.
5. Disconnect the electrical connectors as necessary.
6. If replacing the trim plate, perform the following steps:

6.1.	Remove the rear windshield wiper switch. Refer to Rear Window Wiper and Washer Switch Replacement in Wiper/Washer Systems.

6.2.	If equipped, remove the cigar lighter and 12-volt power supply. Refer to 12-Volt Accessory Power Receptacle Replacement in Power Outlets.

1. If installing a new trim plate, perform the following steps:

1.1.	If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement in Power Outlets.

1.2.	Install the rear windshield wiper switch. Refer to Rear Window Wiper and Washer Switch Replacement in Wiper/Washer Systems.




2. Connect the electrical connectors as necessary.
3. Install the trim plate to the IP. Ensure that all of the retaining clips are properly seated.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the lower trim plate retaining screws.

Tighten
Tighten the screws to 2.5 N·m (22 lb in).

5. Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .