For 1990-2009 cars only
Removal Procedure
- Remove the upper intake manifold cover.
- Open the air bleed valve on top of the fuel manager/filter to release any pressure in the fuel supply system.
- Remove the mounting bolts that connect the fuel manager/filter to the intake manifold.
- Remove the wiring harnesses and fuel hoses.
- Remove the fuel manager/filter by lifting straight up.
- Remove the fuel heater threaded cap nut by using hand pressure or a strap wrench.
- Remove the fuel heater from the filter housing.
- Clean the fuel heater to housing sealing surfaces.
Installation Procedure
- Install the cap seal into filter housing.
- Install the fuel heater.
- Install the threaded cap nut.
- Install the fuel manager/filter (Refer to Fuel Manager/Filter Replacement .
- Install the mounting bolts that connect the fuel manager/filter to the intake manifold.
- Open the air bleed valve on top of the fuel manager/filter to bleed air from fuel supply system. Refer to Fuel Feed Pipe and Return Pipe Purging .
- Install the upper intake manifold cover.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the cap nut securely by hand.
Tighten
Tighten the mounting bolts to 25 N·m (18 lb ft).
